This then necessitates the need for a replacement. Over time due to clogging and other factors, the flow restrictor clogs and greatly hampers the discharge of water from the showerhead. This, therefore, implies that with new restrictor, water comes out with high pressure. The main purpose of the flow restrictor is to ensure that water comes out from the showerhead with enhanced pressure. Can a Moen shower head increase water pressure by doing the replacement?
It gives you the choice of how you would wish to use your water. Old restrictors do not allow water to come out with a good amount of pressure because they are already clogged. You will get water under the desired pressure. This leads to reduced wastages and minimized water bills. It helps a great deal in conserving and saving water. More benefits are also found in replacing the worn-out one for a new one. So many benefits accrue from using a flow restrictor. What are the benefits of doing a Moen flow restrictor replacement? You must first lay a cloth beneath it to avoid damaging the delicate parts. Make the connection tight by the use of the adjustable wrench. Turn it till it becomes firm such that you can no longer turn it around with your arm. Return the showerhead to the shower tap and turn it run in clockwise direction until it becomes tight. Ensure that the O-ring is tightly held to the screen then wrap the tape around the shower arm. Put back the screen into the showerhead, then O-ring in that order. It may cause you to replace the entire showerhead should you damage other components in the head. Exercise a lot of care so as it is easy to damage other things in the showerhead. Take off the restrictor from the showerhead by use of the neck of the screwdriver. The flat side of the screwdriver is well equipped for this task. 
This is in preparation for the extraction of the restrictor. Insert a screwdriver to the center of the flow restrictor.Separate the screen and the O-ring and place them apart. Extract the screen lose too over your palm.
Do not use any tool such as the pliers or even a screwdriver to remove it as it may become damaged easily.
In the showerhead is a rubber that is O-shaped and placed in the neck of the head. Then turn the showerhead connector together with the wrench in an anti-clockwise direction Disconnect the showerhead from the shower pipe and take it off. By use of a soft cloth, tighten the jaws of the wrench over the cloth as well as the connector. If you damage the parts, you may be forced to replace the entire showerhead. They have not complicated steps, but hey demand a lot of care. There are a few steps to follow when removing the flow restrictor. So how do you remove flow restrictor from the Moen handheld showerhead? To find out more about how to remove the flow restrictor, go through the article. 
Care must be taken when opening the showerhead as it contains highly delicate parts. Replacement is, therefore, a good option. Removing the restrictor will solve the problem of pressure, but will cause another problem of non-conservation of water. To do away with this problem, you will need to remove the flow restrictor by opening the showerhead. Restrictors are mostly placed by manufacturers to minimize water loss or even as a way of conserving water. The drop in pressure is occasioned by the clogging of the restrictor. This drop-in pressure should not be as a result of water rationing or dry taps. Have you noticed a consistent drop in the pressure of the water from the shower head you are using? Probably yes.
0 kommentar(er)
